97R5900102 /11 ClickShare CX-20
5.15 Wi-Fi settings, Wireless Client, WPA2-PSK
About WPA2-PSK
WPA2-PSK does not distinguish between individual users, there is 1 password (PSK – Pre-Shared Key) for all
clients connecting to the wireless infrastructure. This makes setup very straightforward. Once connected, all
data transmitted between client and AP (access point) is encrypted using a 256 bit key.
How to start up for WPA2-PSK
1. Select WPA2–PSK from the drop down list next to Authentication Mode.
Image 5–25 Wi-Fi Settings, Wireless Client, WPA-PSK
2. Fill out a Corporate SSID.
The SSID of your corporate wireless infrastructure to which the ClickShare Buttons will connect.
3. Fill out Passphrase.
The key used in WPA2-PSK to authenticate onto the wireless infrastructure. This can be a string of 64
hexadecimal digits or a passphrase of 8 to 63 printable ASCII characters.
4. Click Save changes.
CX-20 Configurator
To Next Page
Loading...
