47R5900102 /11 ClickShare CX-20
Image 3–19
To activate SmartCare, registering the Base Unit in XMS Cloud is required. There are two ways to register
on XMS Cloud.
1. Pc registration: click the link below the QR code to start the registration process. For more
information, see “Pc onboarding”, page 49
2. Mobile registration: scan the QR code on screen or on the card that is included in the box. For more
information, see “Mobile onboarding”, page 50
10. Overview page
Image 3–20
Gives an overview of the current configuration.
Click Finish configuration. When your device is connected to the internet and firmware update was set to
automatic, a software check and an update will be executed. The Configurator starts automatically with a
message that your device is configured.
CX-20 Installation
To Next Page
Loading...
Need help?
General
