4. Lamp & lamp house
5 Nm
9
10
11
Image 4-20
Secure ca th ode
8. Install the side cover of the Lamp House and fasten the two quarter turn screws (reference 1) at the bottom of the cover.
Note: Please e nsure that the quarter turn screws turning w ires are flush w ith the c over or interference will occur while inserting
the Lam p House into the projector.
1
Image 4-21
Install side cover
CAUTION: The “LAMP INFO” parameters wh ich are s tored on a chip inside the Lamp House MUS T be updated
after each installation of an xenon lamp inside the Lamp House. Neglecting this update will result in poor
performance and short life tim e o f the xe non lam p.
A realignment of the xenon lamp in its reflector is req uired af ter the installation o f the xenon lamp in the Lamp
House.
R59770495 DP2K-23B 30/04/2010 39
To Next Page
Loading...
