BARTEC BENKE HYGROPHIL F 5673 - 5.6.9 Serial output

Programming
5-31
HYGROPHIL® F 5673 Operating manual, Software version 1.8.x, 387896MDHEN(14.06.2013)
5.6.9 Serial output
● Open the menu „Serial output“.
● Set the parameters of the serial output as required.
Use the arrow keys to scroll the window.
Parameter
Possible settings
Comments
Cycle Time
Off
10 seconds
1 minute
10 minutes
1 hour
1 day
Time interval after which there is an output to the serial inter-
face.
Package
Minimum
Maximum
Number of measurement variables issued per record.
(Min: Date, Time, Channel, TT, SP, HCDT, DT, state of ER-
ROR-relay, state of Limit-relay)
Max: Date, Time, Channel, TT, SP, WL, VOL%, PPM, DT,
HCDT,FP, MC, VP, state of ERROR-
relay, state of
Limit-relay)
Baudrate
1200
2400
4800
9600
19200
Number of databits
7 Databits
8 Databits
Number of stopbits
1 Stopbit
2 Stopbits
Parity
No Parity
Odd Parity
Even Parity
Send error codes?
Yes
No
You can choose output the error codes or not.
End of line
LF
CRLF
Code to be used for end of line (depending on operating sys-
tem)