Configuring the Camera
BASLER L304
kc 4-41
Draft
Enumerating Saved Bulk Data Files
Bulk data file enumeration allows you to look through a list of existing saved bulk data files.
As an example, assume that you want to see a list of all of the existing saved configuration set
files. To do so, you would follow this procedure:
1. Use a binary write command to set the value of the Control field in the configuration set bulk
data CSR (see page 4-44) to 0x00. Setting the value to 0x00 initiates an enumerate function.
2. Use a binary read command to read the Name field of the configuration set bulk data CSR.
This is the name of an existing saved configuration set file.
3. Use a binary read command to read the value in the Info field of the configuration set bulk
data CSR.
a) If the value is 0x00, it means that the file exists and it is not an activated file. Continue to
step 4.
b) If the value is 0x04, it means that the file exists and it is an activated file. Continue to step
4.
c) If the value is 0x01 no more saved configuration set files exist. Exit the procedure.
4. Use a binary write command to set the value of the Control field in the configuration set bulk
data CSR to 0x01. Setting the value to 0x01 initiates an enumerate next function.
5. Return to step 2.
This procedure would list all of the configuration set bulk data files stored in the computer.
If you wanted to enumerate the existing saved shading value file, you would use a similar
procedure but you would write to and read from the shading value bulk data CSR instead.
Sample code that illustrates how to enumerate bulk data files are available from Basler (see
Section 4.4).
To Next Page
Loading...
Need help?
General
