Baumuller b maXX 5500 - Page 195

X2 Digital inputs/outputs
Assessment Signal edge, programmable
Input current per input 2 mA digital input,
20 mA fast digital input
Input propagation delay Max. 4 ms
Max. 10 µs for fast inputs
Level Low (0 .. 5 V)
High (12 … 28 V)
Output current per output 500 mA
Galvanic separation Optocoupler
Short-circuit resistant Current limited
Deviating thereof pin No. 2, 3: NO contact, without a ground reference
Power rating per NO contact: Max. 30 V, max. 100 mA
Installation
Instruction handbook b maXX BM5500, BM5600, BM5700
Document No.: 5.13008.10
195
of 314
7
Pin assignment X2
Pin No. Assignment Pin No. Assignment
1 N.C.
1)
11 + 24 V (supply digital IN/OUT)
+24 V (supply digital IN/OUT)
2)
12 M24V (supply digital IN/OUT)
2 Ready-to-operate 1 13 (fast) digital input 1 quick stop
3 Ready-to-operate 1 14 (fast) digital input 2
4 Digital output 1 15 Digital input 3
5 Digital output 2 16 Digital input 4
6 Digital output 3 17 Digital input 5
7 Digital output 4 18 Digital input 6
8 N.C.
1)
19 Digital input 7
M24V (supply digital IN/OUT)
2)
20 Digital input 8 / pulse enable
9 N.C.
10 N.C.
1)
only hardware configuration controller 01,
refer to ZTy
pe code– from page 124.
2)
hardware configuration controller from 06,
refer to ZT
ype code– from page 124.