LB 134 12. Technical Data LB 134 UMo II
12. Technical Data LB 134 UMo II
Radiation measurement device for measuring radioactive contaminations
on surfaces with alpha, beta and gamma sources, activities of samples,
gamma and neutron dose rate
Monochrome LCD graphics module with 192x64 pixels, LED backlight,
extended temperature range
Foil keyboard, 6 keys with "cracking noise", 4 softkeys, 1x device on/off,
1x sound/LCD backlight on/off
2 LEDs for alarm signal and function control
W x H x D 160 mm x 160 mm x 55 mm
Temperature range operation: -20°C ... +40°C (no condensation)
Temperature range storage: -40°C ... +60°C
4 batteries type "AA", Mignon or corresponding Ni-MH rechargeable
batteries. Rechargeable batteries can be recharged in the detector via
plug-in power supply or wall bracket.
Primary voltage: Wide range input 90-264VAC 50/60 Hz
1.9 Ah Ni-MH rechargeable batteries, LB 134 + internal DR: 10 h
2.6 Ah batteries, LB 134 + internal DR: 15 h
USB interfaces: Host for USB stick, device for PC connection
Meas. modes for all probes
Search mode, ratemeter, counter/timer
Nuclide list for contamination
Factory-defined calibration factors for over 50 nuclides (editable)
Measured values can be saved and output via USB interface.
2400 measured values with date and time
Software update via USB interface
Language selectable, German / English
Different access rights to features/measurement modes and parameters
adjustable
Threshold values for each radionuclide separately adjustable
Acoustic: Piezoelectric oscillator 2.5-3 kHz alarm as intermittent
continuous tone
Single pulse (switchable) as tone burst
LED signals for threshold exceeded or function display
Text messages on the display for overrange and detector failure
In accordance with section 3 of the German Medical Products Act, the measuring device is not intended by the
manufacturer to be used on human beings and therefore is not a medical device within the meaning of the Act.
Subject to change without notice.
To Next Page
Loading...
