6.11 Parameters
The following device parameters are set on this menu:
Figure 6.29: Menu items under Parameters
6.11.1 Date/Time
Here you can check and set the date and time. This time infor-
mation is used when storing the measured values.
If the memory with the time information is deleted (e.g. by stor-
ing the LB 134 without batteries), the date and time will be au-
tomatically queried when the device is turned on. The entry is
made as shown below: DD.MM.YYYY or HH:MM:SS.
Figure 6.30: Entering the date and time
To Next Page
Loading...
