Figure 6.33: Hardware parameters
In a single-channel probe, e.g. a dose rate probe, the parame-
ters for the second channel do not appear and the table is
slightly shorter. The parameters in detail:
Detector Type:
The LB number of the detector used is displayed here; it may
also be the internal dose rate probe (LB 1346). This parameter
cannot be edited.
Ser. No. Detector:
The serial number of the detector is entered at the factory or
taken from the probe.
Ser. No. Device:
The serial number of the LB 134 device is entered at the facto-
ry; it cannot be edited.
Control Voltage (V):
For many probes, the control voltage is not needed for the
probe high voltage, with a few exceptions. Normally, the value
is set to 2.5V.
To Next Page
Loading...
