113
BOCA PRO16 Reference Guide
COMMAND MEANING
&F Restore Factory Defaults
Your modem comes with factory default settings for all communications
settings and S Registers.
The &F command enables you to restore the factory default values to the
command settings and S Registers.
This command does not reset stored phone numbers, security, or
encryption settings.
The &F1 command selects non-error correction factory defaults. The
defaults selected are:
X0 &K0 &D2 \N1 %C0
The &F2 command selects synchronous mode factory defaults. The
defaults selected are:
B13 E0 Q1 &M2
You must use the &W command if you wish to save the default values
to non-volatile memory, and thus preserve these values when you
switch the modem off.
FIf you issue the &F command while the modem is off-hook, an
ERROR message will be returned.
Options
AT&F Restore Command and S Registers to Factory Defaults
AT&F1 Select non-error correction factory defaults
AT&F2 Select synchronous mode factory defaults
See Also
&V command View the Active Configuration
Z command Restore Configuration
&W command Save Configuration
Command Descriptions
Command
Descriptions
pro16ref.pm6 6/14/96, 2:38 PM113
To Next Page
Loading...