155
BOCA PRO16 Reference Guide
COMMAND MEANING
\S Display Active Configuration
The \S command allows you to display the current active configuration.
The following is a sample of the \S command output:
&C DCD Signal
= 1*Asserted when carrier is valid
&D DTR Signal goes low
= 0*Ignored
&G Guard Tones
= 0*Off
&H Sync Clock Control
= 0*Clocks always present in sync mode
&K Flow Control
= 9*Auto CTS or XOFF (to DTE only)
&L Leased Line
= 0*Disabled (PSTN mode)
&M Synchronous Mode
= 0*Asynchronous
&N Abort Dial Character
= 1*Abort dial with any character
&P Pulse Dial Ratio
= 1*33/67 (Aust/NZ/UK)
&R Sync RTS/CTS Control
= 0*CTS follows RTS on-line, CTS high off-
line
&S DSR Signal
= 1*Asserted at start of handshake
Page 002 Press Space for next page, BackSpace for
previous page, CR to end
Options
AT\S Display Active Configuration
Command Descriptions
Command
Descriptions
pro16ref.pm6 6/14/96, 2:39 PM155
To Next Page
Loading...