Boca Pro16 Series - Overridden Settings; V.25 Bis Commands

70
BOCA PRO16 Reference Guide
The setting of the Option switches always take precedence over the #M
command.
The %R2 option will be required for most V.25bis setups. This setting
ensures that the CTS signal is only asserted when the modem is ready to
accept a new command (in command mode).
Overridden Settings
Almost all AT commands and S Registers stored before entering V.25bis
mode will have effect except for the following commands.
AT Command V.25bis Operation
&D Will act as if &D2 is selected
S0 Will act as if S0=1
These override settings are not stored in your modem’s non-volatile
memory; they are active only while V.25bis command mode is active. If
you issue the &V command to view the modem’s configuration the
original settings will be displayed.
V.25bis Commands
Six V.25bis commands are supported by your modem:
Command Description
CRN n Dial phone number n
CRS x Dial stored phone number x
PRN x:n Save n as stored phone number x
DIC Disregard an incoming call
CIC Connect to an incoming call
RST Restore factory default parameters
V.25bis Operations
V.25bis
Operations
pro16ref.pm6 6/14/96, 2:37 PM70