Boca Pro16 Series - Ln Transmit Level (Data Mode); M Mode LED Indication

143
BOCA PRO16 Reference Guide
COMMAND MEANING
%Ln Transmit Level
This command allows you to alter the transmit level of your modem.
The command is in the form:
AT%Ln
where n is the level you wish to select.
For example:
To set the transmit level to -15dBm:
• Type: AT%L15 <E>
WARNING
Do not change the transmit level of your modem unless you
have a specific reason for doing so. Changing the transmit
level of your modem may adversely affect its performance.
Options
11-19 (13 default) -11dB-19dB transmit level
Range
11-19
COMMAND MEANING
%M Mode LED Indication
If your modem has three ‘Mode’ LEDs, you can use the %M command
to determine whether the LEDs will indicate the line speed or the quality
of the line.
The Mode LEDs provide an indication of the line speed or line quality
when you are connected to another modem only.
If you have issued the %M0 command, refer to the table on the underside
of your modem to determine the line speed.
If you have issued the %M1 command:
Mode 1 LED will illuminate whenever the line quality is judged to be
poor, Mode 2 LED will flash whenever a V.42 or MNP error is detected
Command Descriptions
Command
Descriptions
pro16ref.pm6 6/14/96, 2:38 PM143