145
BOCA PRO16 Reference Guide
Options
AT%Q Display line signal quality
Examples
• Type: AT%Q <E>
The line signal quality is displayed.
COMMAND MEANING
%R CTS Override
The %R command allows you to determine the state of the CTS signal.
This command is intended to replace the CTS switch if your modem does
not have one.
This command overrides any &R setting.
FThe %R command does not revert to the default setting after an ATZ,
AT&F or modem power off is performed.
Options
n AT%R0 &R command determines the state of CTS
AT%R1 CTS always follows RTS (both in on-line state and local
command state)
AT%R2 V.25bis mode: CTS on when ready to accept a command
See Also
&R Sync RTS/CTS control
S Register 26 RTS/CTS Delay
Range
0-2
Command Descriptions
Command
Descriptions
pro16ref.pm6 6/14/96, 2:39 PM145
To Next Page
Loading...