Boca Pro16 Series - U V.42 Response Codes

To Next Page

To Previous Page

147

BOCA PRO16 Reference Guide

COMMAND MEANING

%U V.42 Response Code

The %U command allows you to change the response codes issued by

your modem when a V.42 connection is established. Compression &

encryption messages will be added if active.

After the %U1 command is issued, if your modem establishes a connec-

tion with V.42 error correction, a CONNECT/LAP-M message will be

sent to your computer. If an MNP connection is established, a CON-

NECT/REL message will be sent to your computer.

After the %U2 command is issued, a CONNECT/REL-10 or CON-

NECT/LAP-M message will be sent to your computer to indicate an

MNP 10 or V.42 connection has been established.

FThe %U command does not revert to the default setting after an ATZ,

AT&F or modem power off is performed.

The %U command has no effect on numeric response codes issued by the

modem.

Options

n AT%U0 Standard error correction response codes

AT%U1 V.42 response codes sent when a V.42 error corrected

connection is established

AT%U2

Append /LAP-M or/REL (2,4,10) or /MNP-5 or /V.42bis or

/DES messages to the CONNECT message when established