83
BOCA PRO16 Reference Guide
COMMAND MEANING
**** Remote Access Sequence
When the modem is connected to a remote modem and is in on-line state,
the remote modem may type this command to force the modem to enter
Remote Access mode.
Remote Access mode simply means the remote modem will be able to
issue AT commands to your modem, just as if you were typing them at
your computer keyboard.
Remote Access mode may be switched on or off with the #A command.
Remote Access mode is password protected by default.
To enter Remote Access mode, the operator of the remote modem
should:
• Type: ****
The remote operator must wait one second before and after typing the
Remote Access sequence. The AT command must not be typed in front
of the Remote Access sequence, nor type a carriage return after it. You
may change the character used in the Remote Access sequence by
changing the value of S Register 67.
If the #A2 command has been issued to your modem, when it receives
a request to enter Remote Access mode, it displays:
Enter Password:
on the computer screen of the remote operator. The remote operator
must type your modem’s security menu password and press ENTER.
Each letter of the Remote Access password is displayed on the remote
computer screen as # character.
If no password has been saved, remote access is denied.
If the password is successfully typed, the following prompt appear on
the remote computer screen:
AT
Command Descriptions
Command
Descriptions
pro16ref.pm6 6/14/96, 2:37 PM83
To Next Page
Loading...