141
BOCA PRO16 Reference Guide
COMMAND MEANING
%H MNP 10 Negotiation Speed
This command allows you to determine the speed at which your modem
will begin MNP 10 connections.
MNP 10 can change the speed of the connection depending upon the
quality of the line. This command sets the initial connection speed only.
By initiating MNP 10 at a lower speed you can ensure that an error
correcting link is established when this may not be possible at the highest
speeds.
Refer to the chapter titled ‘Error Correction’ for details of MNP 10.
Options
n AT%H0 Use the B setting for initial MNP 10 connection speed.
The B setting is the maximum speed.
AT%H1 Initial connection speed is made at 1200 bps (V.22).
The maximum speed is defined by the B setting.
AT%H2
Initial connection made at 4800 bps (V.32). The maximum
speed is limited by the B setting.
AT%H3
Initial connection made at 9600 bps (V.32). The maximum
speed is limited by the B setting.
See Also
#K command MNP 10 mode
J dial modifier Initiate MNP 10 at 1200 bps
K dial modifier MNP 10 Cellular Power level
L dial modifier Initiate MNP 10 at 4800 bps
Range
0-3, 9
Command Descriptions
Command
Descriptions
pro16ref.pm6 6/14/96, 2:38 PM141
To Next Page
Loading...