64
BOCA PRO16 Reference Guide
Using DTR to Dial
You may commence dialing by having your computer raise its DTR
signal.
Place switch 6 in the Off (or Right) position.
• Connect your modem to a personal computer — refer to the modem
Installation Guide for details
• Run a communications program and enter “local mode” or “terminal
mode”
• Type: AT&Z0=phoneno <E>
Where “phoneno” is the telephone number you want your modem to
dial. This stores the number as stored telephone number zero.
FIf you are using your modem over leased lines, do not store a phone
number.
• Type: AT&D2&M4 <E>
or:
Type: AT&D2&M2 <E>
Issue the &M4 command if you wish to use asynchronous communica-
tions; issue &M2 if you wish to use synchronous communications.
• Type: AT&Wn <E>
The modem set up is saved to profile n=0-3
• Place Option switch 8 in the On (or Left) position.
• If necessary, use the Mode button to select the required communica-
tion speed
The connection speed of the modem is indicated by the Mode LEDs.
Refer to the table printed in your modem Installation Guide; it shows the
meaning of each combination of Mode LEDs.
• Raise the DTR signal on your computer
Dumb Mode Operation
Dumb Mode
Operation
pro16ref.pm6 6/14/96, 2:37 PM64
To Next Page
Loading...