208
BOCA PRO16 Reference Guide
SAMPLE SETUPS
These sample setups are example of how commands can be used. Some
of these commands may not be supported by your modem.
Asynchronous Mode
Calling a BBS or EMail system
Terminal Software Speed: 38,400 bps, 19,200 bps, or 9600 bps
Command: ATB0\N3%C2&K3X5\V8
Explanation:
B0 Selects the modem to connect at the highest possible speed
supported by the remote system.
\N3 Selects error correction. Will fallback to non-error correction
mode if the other modem does not support it.
%C2 Selects V.42bis data compression. The modem will fallback to
non-compression mode the other modem does not support it.
If you wish to fallback to MNP class 5 data compression (and
then non-compression mode) issue the %C3 command instead
of %C2.
&K3 Selects RTS/CTS flow control. Your communications software
must also have RTS/CTS flow control selected. This ensures
data is not lost between your modem and computer. Use &K4
if your communications software only supports XON/XOFF
flow control.
X5 Selects extended response codes. Will report to you the speed
of the connection your modem establishes with the remote
modem.
\V8
Displays connection details. This provides on-screen information
about the type of error correction, data compression and other
parameters negotiated between the modems. If your
communications software is dialing the remote modem, issue
the command \V0 instead of \V8.
Sample Setups
Sample Setups
pro16ref.pm6 6/14/96, 2:39 PM208
To Next Page