209
BOCA PRO16 Reference Guide
Using your modem as an Auto-Answer modem
Terminal Software Speed: 38,400 bps or 19,200 bps
Command: ATB0S0=2\N3%C2&K3X5\V8
Explanation:
B0 Allows the modem to auto-range, in order to connect at the
highest possible speed with the remote modem.
S0=2 Selects the modem to auto-answer incoming calls after
two rings.
\N3 Selects error correction. Will fallback to non-error correction
mode if the other modem does not support it.
%C2 Selects V.42bis data compression. The modem will fallback to
non-compression mode the other modem does not support it.
If you wish to fallback to MNP class 5 data compression (and
then non-compression mode) issue the %C3 command instead
of %C2.
&K3 Selects RTS/CTS flow control. Your communications software
must also have RTS/CTS flow control selected. This ensures
data is not lost between your modem and computer.
X5 Selects extended response codes. Will report to you the speed
of the connection your modem establishes with the remote
modem.
\V8
Displays connection details. This provides on-screen information
about the type of error correction, data compression and other
parameters negotiated between the modems. If your
communications software is dialing the remote modem, issue
the command \V0 instead of \V8.
Sample Setups
Sample Setups
pro16ref.pm6 6/14/96, 2:39 PM209
To Next Page
Loading...