Boca Pro16 Series

To Next Page

To Previous Page

153

BOCA PRO16 Reference Guide

FIt is necessary to select flow control (&K command) between the

modem and your computer when you use constant speed mode.

AT\N1 selects variable speed mode. With variable speed mode selected,

the modem adjusts its terminal speed to match line speed. If the terminal

speed is higher than the modem’s maximum line speed, the modem will

attempt to connect using its highest speed.

FFlow control will be ignored when your modem is configured for

variable speed mode or is in local command state. Flow control is only

available when the modem is configured for constant speed mode or

reliable or auto-reliable modes and is operating in on-line state.

When answering, the modem automatically adjusts its terminal speed to

match the standard used by the calling modem.

FWith variable speed mode selected, your modem’s terminal speed

should not be changed once connected to another modem.

Changes to \N when on-line will not take effect until the next connec-

tion.

Options

AT\N0 Constant speed mode

AT\N1 Variable speed mode

AT\N2 MNP Reliable mode

n AT\N3 V.42/MNP auto-reliable mode

AT\N4 V.42 reliable mode

AT\N5 V.42 auto-reliable mode

AT\N6 V.42/MNP reliable mode with fallback to MNP reliable

mode, disconnect if MNP not supported by remote modem.

AT\N7 MNP auto-reliable mode

Boca Pro16 Series - Page 153