Operating Instructions ACTIVE 06/0762
62 Operating Instructions ACTIVE 06/07
6.5.4 Selecting the Destination
Select the destination (dSt.) of the copy operation (application-specific). The data
source is transferred to the selected target (download).
• Use the arrow keys to select the destination (dSt.) for the copied data
(download). Depending on the data source selected, either the data records of the
frequency inverter (dSt. x) or empty files of the control unit (dSt. F y) can be used
as the target.
• Confirm the selection by pressing the ENT key. The copy process is started and
COPY is displayed.
Display Description
dSt. 0 The four data records of the frequency inverter are overwritten.
dSt. 1 The data are copied to data record 1 of the frequency inverter.
dSt. 2 The data are copied to data record 2 of the frequency inverter.
dSt. 3 The data are copied to data record 3 of the frequency inverter.
dSt. 4 The data are copied to data record 4 of the frequency inverter.
dSt. F1 The data are copied to file 1 of the control unit.
1)
dSt. F2 The data are copied to file 2 of the control unit.
1)
dSt. F3 The data are copied to file 3 of the control unit.
1)
dSt. F4 The data are copied to file 4 of the control unit.
1)
dSt. F5 The data are copied to file 5 of the control unit.
1)
dSt. F6 The data are copied to file 6 of the control unit.
1)
dSt. F7 The data are copied to file 7 of the control unit.
1)
dSt. F8 The data are copied to file 8 of the control unit.
1)
1)
Already existing files are not offered as possible targets.
6.5.5 Copy Operation
Attention! Before the parameter settings are transferred to the frequency inverter,
the individual parameter values are checked.
The value range and the parameter settings can differ according to the
power range of the frequency inverter. If parameter values are outside
of the value range, an error message will be displayed.
While the copy operation is in process, the message COPY
and, as a progress indicator, the number of the currently cop-
ied parameter will be displayed.
In the case of the Act function, the active parameter values
are copied only. Using the ALL function, parameters which are
not relevant to the selected configuration are copied, too.
Depending on the selected copy function (ALL or Act), the
copy operation is completed after some 100 seconds and the
display reads rdY.
Press the ENT key to switch to the copy menu. Use the ESC
key to switch to the target selection menu.
If the ESC key is pressed during the copy operation, the copy
operation is aborted before the transmission of the data is
complete. The message Abr and the number of the last pa-
rameter which was copied are displayed.
Press the ENT key to return to the selection in the copy menu.
Use the ESC key to switch to the target selection menu.
To Next Page
Loading...
Need help?
General
