Breas Nippy 4 - Washing a Coarse Filter

2 First Place the filters in the air inlet
compartment, with the coarse filter outside
the fine filter.
3 Close the side panel carefully for not displacing the filters while closing. For detailed
information about closing the side panel, see 3.3.1 Detaching and Reattaching the Side Panels,
page 30.
Cooling Air Filter
NOTE
The filter shall be washed at least once a week and replaced every second year. See 7.2.1
Washing a coarse filter, page 113 for washing instructions.
The cooling air inlet filter is located at the bottom left side of the ventilator.
1 Open the cooling air filter compartment
by pulling at the top of the lid.
2 Remove the filter and wash or replace it.
3 Put back the filter and close the lid.
7.2.1 Washing a coarse filter
1 Wash the filter using warm water and a mild soap.
2 Rinse thoroughly.
3 Dry the filter by squeezing it out in a towel. Do not wring the filter.
4 Make sure the filter is completely dry before inserting.
Cleaning and Maintenance
113
Doc. 006553 M-6 User Manual