5.12.8 Using the Nippy 4 with the Trolley
Intended Use
The intended use of the trolley system is to allow patient mobility while receiving ventilator
treatment. The trolley shall only be used in indoor, hospital environment. The trolley system
consists of a trolley base and a mounting bracket.
This section describes how to use the Nippy 4 and a trolley with mounting bracket.
Mount and dismount the Nippy 4 as shown in the picture:
The bottom plate is mounted to the trolley using two screws.
Be careful when handling the trolley with the ventilator mounted, in order to avoid any risk
of the trolley falling. The trolley can be tipped 10° and return to vertical position, when
loaded in accordance with the weight specifications below.
WARNING!
The maximum total weight of the trolley and added accessories is 37 kg (82 lbs). (Trolley
base weight = 12 kg (26 lbs), maximum externally added load = 25 kg (55 lbs).)
• The maximum load of the trolley basket is 0.9 kg (2 lbs).
• The maximum load of the IV-pole is 3 kg (6.5 lbs).
• The maximum load of the trolley rail is 9 kg (20 lbs).
• The maximum load of the E-cylinder holder is 7.9 kg (17.5 lbs).
No maintenance is required.
How to Use the Nippy 4
71
Doc. 006553 M-6 User Manual
To Next Page
Loading...
