5 You can also press the Start/Stop
button shortly and then confirm by pressing
the Start button at top right.
6 Select Yes/No if asked to “Perform Pre-use Test”.
5.1.2 Start the Pressure Ramp
If the treatment has been configured to allow pressure ramp, it can be started or stopped by
the ramp button. The ramp buttons are only available after the treatment has started.
1 Press the Start Ramp button.
2 Confirm to start the ramp.
3 Read and acknowledge the information
message regarding reduced alarm
functionality during the ramp period.
How to Use the Nippy 4
43
Doc. 006553 M-6 User Manual
To Next Page
Loading...
