Brother BAS-600 - Page 18

Sewing end
25mm
4 l
I.
115mm
140mm
,.
J
Darts
~~
3) Replacing the marking light bulb
Ex. 2: When the darts are the reference
* If the seam length is 140 mm, and divided 25
mm to the right and 115 mm to the left based
on the darts
* If the marking lights are adjusted as shown in
the figure on the left,
and the bodice darts are
centered on the right
[tit] mark and the sewing
end position on the right side of the bodice is
aligned with the center of the left [ tit 1 mark, a
welt will be sewn as shown in the figure on the
left.
1. Turn the cap 8 counterclockwise to remove it
from the receptacle@.
2. While pressing in the light bulb @, turn it
counterclockwise to remove it from the cap 0.
Replace the bulb@.
3. Reassemble by reversing s'eps 1. and 2.
-14-
From the library of: Superior Sewing Machine & Supply LLC