Brother BAS-600 - Installation; Setting up the Table; Installing the Spool Stand; Installing the Material Holder

INSTALLATION
1. Setting up the table
2. Installing the treadle
-2-
* Set the machine table on a level surface.
Loosen
the nut 0 I and turn the caster @ to
adjust the height.
* Lock the casters so the table will not move.
Lower
the lever@ to lock the caster@.
Lower the Ievere to move the table.
* Remove the three screws 0 I and open the side
panel@.
Plug the 12Pconnectore forthetreadle@ into
the side panel connector block.
4. Installing the material holder
* Set the material holder 0 onto the stud @ and
secure with
the screw@).
From the library of: Superior Sewing Machine & Supply LLC