Brother BAS-600 - Removing the Feed Mechanism

1. Disconnect the two connectors@ in the DC motor assembly 0.
2. Loosen the two bolts@ and remove the timing belt 9.
3. Remove the two bolts@, the flat and spring washers, and the DC motor assembly 0.
(2) Removing the corner knife cylinder assembly
(3) Removing
the corner knife adjusting base
(4) Removing the feed mechanism assembly
-31-
1. Loosen the screw 0 and remove the cylinder
sensor@ downward.
2. Disconnect the air hoses@ and 9.
3. Remove the two bolts @),the washer, the spring
washer and
the corner knife cylinder assembly
@.
* Mark the hoses with tape to assure correct
reconnecti on.
1. Remove the spring 0.
2. Remove the two bolts @, the flat and spring
washers, and
the corner knife adjusting base @.
* Do not remove or disassembly the feed
mechanism unless absolutely necessary.
1. Disconnect the air hose 0.
2. Remove the four bolts @ and the feed
mechanism
assembly@.
* Be sure not to drop the feed mechanism
assembly@.
,~
From the library of: Superior Sewing Machine & Supply LLC