14. Adjusting
the
padding cloth presser
foot
(1) Adjusting
the
padding cloth presser
foot
spring (R)
height
.............
.......
Same height as
the
table
* When the padding cloth
presser
foot
spring
(R)
0
is
raised
(when the treadle
is
pressed
back),
the
installation surface should be
the
same
height
as
the table.
(Adjustment)
Loosen
the
nut
@
of
the cylinder
assembly
@,and
adjust the length
of
the cylinder rod
so
that
the
distance between the
top
of
the cylinder and the
spring
fitting
shaft e
is
33.5
mm.
Also, loosen the
nut
@)and
adjust the height
of
the
cylinder
@
so
that
the padding cloth
presser
foot
spring
(R)
0 holds the padding cloth when the
padding
cloth
presser
foot
spring
(R)
0
is
down,
and then tighten the
nut
@.
(2) Adjusting
the
padding cloth presser
foot
spring
(L)
height
-76-
1.
When the padding cloth
presser
foot
spring
(L)
0
is
raised, the padding cloth pusher @ should
be 2
mm
higher than the table.
(Adjustment)
Remove
the
two
screws
@ and the cylinder
assembly
e from the table.
Loosen
the
nut
@,and adjust the length
of
the
cylinder rod, then tighten the
nut@.
Remount the cylinder assembly 8
to
the table
with
the
screws@).
2.
Make
sure
the spring tension
of
the
two
springs
(R)
and
(L)
is
adjusted
so
that
when the padding
cloth or sacking
is
being positioned, the cloth
will
not
slip easily, and
so
that
when
the
carriage feed operates, the padding cloth and
sacking
can
be removed smoothly.
3.
Make
sure
that
when
sewing
has
been
completed and the carriage feed returns
to
the
home position
with
the
material
held,
the
material does
not
catch on the spring
(R)
or
(L).
From the library of: Superior Sewing Machine & Supply LLC
To Next Page
Loading...
