Brother BAS-600 - Adjusting the Pickup Type Stacker

16. Adjusting the pickup type stacker
(1) Adjusting the stacker table position
1. .Stacker table 0 height
Six steps
There are six vertical adjustment positions for the stacker table depending upon the installation position
of the cloth stock arm @.
Raise the arm to reduce the stock number; lower the arm to increase the number.
2. Stacker table angle
The stacker table
can be adjusted to one of seven angles depending upon the hole in the stacker table 0
into which the table supporter bar@ is inserted.
* When the above stacker table 0 height and angle adjustments have been completed, move the
stacker arm 0 in the direction of normal operation by hand to make sure the arm does not strike the
stacker table 0. If the arm strikes the table, readjust the angle and height.
-79-
From the library of: Superior Sewing Machine & Supply LLC