Brother BAS-600 - Removing the Machine Head

4. Removing the machine head
* This should be done after removing the face plate and fixed knife assemblies from the head.
* Follow the procedures below if the face plate assembly is attached. (The fixed knife assembly has been
removed.)
1. Disconnect the two air hoses @ from the two S-elbows 0.
2. Loosen the screw@) and remove the cylinder sensor e.
3. Disconnect the two air hoses@ from the twoS-elbows@.
4. Disconnect the two air hoses@) and@) from the two cylinder assemblies f).
5. Disconnect the connector Cli> at the back of the machine head. ~
6. Remove the two bolts 4D and the lamp bracket@. ~ \
7. Tilt the machine head until it stops.
8. Remove the V-belt.
9. Disconnect the detector connector @ from the PCB.
10. Lower the head from the table.
-29-
0
From the library of: Superior Sewing Machine & Supply LLC