Brother BAS-600 - Page 56

<Adjusting the carriage feed height>
* The carriage feed front should be approximately 20 mm high when they are at their home positions.
-- -- "!!A- - -- --
,------ 'fl
qr I
20mm
--f
20mm ,
-----------------------------------~
(Adjustment)
After loosening the nut 0, adjust the height using the bolt @.
Loosen the bolt@ to raise, tighten the bolt @ to lower, the carriage feeds.
* At this time, check that the flap presser does not strike the machine head when setting the power
switch
to OFF and manually move the carriage feeds back and forth.
-52-
From the library of: Superior Sewing Machine & Supply LLC