Confidential
2-15
Error
Code
Contents
Refer to
page:
8115 The paper size and paper type of each paper tray set during print setting
are different from before printing. This error occurs when the MP tray has
been specified as a pickup tray with the highest priority and Glossy paper
has been specified as the paper type in auto tray switching print.
2-44
8120 Recording paper size error (during PC printing/Copy/AirPrint printing)
The registration sensor and paper width sensor detect that the size of the
loaded recording paper does not match the recording paper size setting.
2-42
8200 Paper jam
Paper width sensor cannot detect leading edge or width of recording
papers.
2-45
8400 Paper jam
Registration sensor stays in paper feeding state even after completion of
paper ejection action.
2-45
8700 Paper jam
Switchback sensor stays in paper feeding state even after completion of
paper ejection action.
2-46
8800 Paper jam
Switchback sensor cannot detect paper feeding state even papers are
fed during printing.
2-46
8900 Paper width sensor cannot detect origin specified on the paper feed
roller.
2-47
8F00 Paper feed motor cannot stop. 2-47
8F01 PF encoder sensor cannot detect rotation of the paper feed motor. 2-47
A000 Time out occurred during data transfer for second side document
scanning.
2-48
A100 Document scanner sensor detects that document scanner is open. 2-48
A200 Document scanning position sensor detects length of document 900 mm
or more.
2-48
A300
Document detection sensor detects that document is pulled out during
document scanning. Or, the document scanning position sensor cannot
detect document within specified time.
2-49
A400 ADF cover sensor detects that ADF cover is open. 2-49
A700 Type of cis unit and CIS type input value does not match. 2-49
AD00 The required number of pixels of the scanning data is not output, and it
does not finish normally.
2-50
AF00 CIS positioning abnormal (Home position cannot be found) 2-50
BF00 Document scanning position sensor detects size that its length does not
fit duplex scanning.
2-50
D100 Modem PCB initialization failed. 2-51
D200 SDAA communication failure 2-51
D800 Touch panel initialization failed. 2-51
E200 Wired LAN MAC address not registered. 2-51
E300 Wireless LAN connection error 2-51
E600 Main PCB EEPROM write error 2-51
To Next Page
Loading...
Need help?
General
