1 - 26
(4) If pushing all media sensors, “MediaSensor 1 to 5” change to “Done” as follows.
Fig. 39 “Sensor test” screen
(5) Close the top cover ASSY, and the following message is displayed if the
displayed all sensors on the “Realtime monitor” field is changed from “Undo” to
“Done”. And then the inspection screen is closed. The inspection is completed.
Fig. 40 Completing “Media and cover sensors check”
NOTE: It take a little time for a while until the inspection screen is closed after
displaying the message.
Push the displayed sensors.
If “MediaSensor 1 to 5”
change to “Done”, close the
top cover ASSY to change the
“CoverSensor” to “Done”.
The state of the sensor is displayed in real time.
Undo: Unchecked sensor
Done: Checked sensor
To Next Page
Loading...
