III - 36
(3) Set the SB PCB ASSY onto the panel cover with the two screws.
NOTE: Confirm that the cover sensor arm moves smoothly.
(4) Route the harness of the SB PCB ASSY as shown in the figure below.
Fig. 3.5-12 Reassembling the Panel Cover (3)
(5) Pass the harness of the SB PCB ASSY through the hole of the under cover.
Fig. 3.5-13 Reassembling the Panel Cover (4)
NOTE: For installing the panel cover to the upper cover, refer to “[11] Installing the
Panel Cover”.
Screws
Panel cover
SB PCB ASSY
Panel cover
Rib
Harness of the SB
PCB ASSY
Cover sensor arm
Under cover
Harness of
the SB PCB ASSY
Hole
To Next Page
Loading...
