III - 49
(2) Pass the flat cable of the tape sensor PCB ASSY into the hole on the upper
cover.
(3) Set the insert guide onto the upper cover with the two screws.
Fig. 3.5-30 Reassembling the Upper Cover and the Under Cover (2)
(4) Turn the upper cover upside down, and then pass the flat cable of the tape
sensor PCB ASSY through the guide of the upper cover.
Fig. 3.5-31 Reassembling the Upper Cover and the Under Cover (3)
Screws
Insert guide
Upper cover
Hole
Flat cable of the
tape sensor PCB ASSY
Guide
Upper cover
Flat cable of the tape sensor PCB ASSY
To Next Page
Loading...
