Brother S-710A - 5-7. Lubrication System Component Disassembly (Wick Holder and Oil Tube); 5-8. Oil Tank, Bed Under Cover, and Sub Tank Disassembly

5. DISASSEMBLY
SL-710A
20
5-7. Wick holder and oil tube (Thread take-up lever)
5-8. Oil tank, Bed under cover and sub tank
<DD7100A, 710A>
4 Screw [Loosen]
2 Screws [2 pcs]
3 Wick holde
r
1 Wick [Untie the knot]
5 Oil tube
[ Remove from underneath machine head ]
1673M
1672M
1674M
2 Screw [Loosen]
10 Fel
t
9 Bed under cove
r
3 Oil tubes
11 Screws [2 pcs]
12 Sub tan
k
1 Screw
Lubricating
oil
Lubricating oil
4 Screws [2 pcs]
5 Oil tan
k
1) Place a dish under the lubricating oil
outlet, and then remove the screw and
drain the lubricating oil.
2) Securely tighten the screw into the
lubricating oil outlet.
While holding a pan under the gear box,
loosen the eight screws.
* The oil inside the gear box will start flowing
out from the gear box when you start to
loosen the eight screws.
-3[][] -4[][]
7 Knee lifter arm connecting rod
6
Shoulder screw
1675M
8 Screws
[8 pcs]