Brother S-710A - 6-22. Oil Tank Assembly

6. ASSEMBLY
SL-710A
54
6-22. Oil tank
<DD7100A, 710A>
1. Install the oil tank (1) to the bed with the two screws
(2).
2. Place the tube clip (4) onto the oil tube (3).
3. Insert the oil tube (3) into the sub tank (5), and clamp it
with the tube clip (4).
4. Insert the oil tube [L=110] (6) into the oil feeding pipe
(7), and insert oil tube MS (8) into the oil feeding pipe
(9).
5. Insert the oil tube (10) from the horizontal feed shaft
into the hole (11) at the rear of the oil tank (1).
<DD7100>
1. Install the oil tank (1) to the bed with the two screws
(2).
2. Place the tube clip (4) onto the oil tube (3).
3. Insert the oil tube (3) into the oil gauge guide (5), and
clamp it with the tube clip (4).
4. Insert oil tube S (6) into the oil feeding pipe (7), and
insert oil tube M (8) into the oil feeding pipe (9).
5. Insert the oil tube (10) from the horizontal feed shaft
into the hole (11) at the rear of the oil tank (1).
6. Insert the oil tube (13) from the oil gauge guide (5) into
the terminal (14).
1793M
(9)
(8)
(7)
(5)
(1)
(10)
(4)
(11)
(6)
(2)
(3)
1794M
(9)
(13)
(6)
(7)
(8)
(10)
(5)
(14)
(11)
(4)
(1)
(2)
(3)