Brother S-7300A - Page 25

S-7300A
3. FUNCTION SETTINGS
14
Sewing program settings (400 to 499)
No. Setting range
Initial
value
Setting
units
Setting details
400
ON/OFF
OFF
－
Stopping during start backtacking and sewing speed
ON: When the treadle is returned to the neutral position, start backtacking
can be stopped before it is finished, and the speed during start
backtacking becomes the speed corresponding to the treadle
depression amount (low speed - start backtacking speed)
OFF: When the treadle is returned to the neutral position, start backtacking
ends, sewing stops and the sewing speed becomes the start
backtacking speed (constant)
401
ON/OFF
ON
－
Feed direction when sewing machine motor is stopped immediately after
start backtacking is complete
OFF: Sewing machine motor stops after start backtacking is
complete
* If MSW-400 is set to "OFF", operation occurs when the treadle
is depressed slightly.
ON: After start backtack sewing, the feed moves forward, then
the sewing machine motor stops.
402
1
～
2
1
1
Fixed stitch sewing load FUNC when stitch control in reverse direction.
1: Reverse stitch sewing when hand switch is ON
2: Fixed stitch sewing when hand switch is ON
403
300
～
4000
(sti/min)
4000
100
1st stitch sewing speed for slow start original pattern
404
300
～
4000
(sti/min)
4000
100
2nd stitch sewing speed for slow start original pattern
405
300
～
4000
(sti/min)
4000
100
3rd stitch sewing speed for slow start original pattern
406
300
～
4000
(sti/min)
4000
100
4th stitch sewing speed for slow start original pattern
407
ON/OFF
OFF
－
Synchronize with main pitch of backtack sewing pitch
ON: Synchronized
OFF: Not synchronized
450
ON/OFF
OFF
－
Correction sewing using hand switch after thread trimming
ON: Enabled
OFF: Prohibited (switch operation disabled)
451
0
～
1
1
1
Shifting speed for end backtack sewing
0:End B/T sewing starts after deceleration speed to inching speed.
1:End B/T sewing starts after deceleration speed to end B/T speed.
(*) This can shorten cycle times.
455
OFF, 1
～
2
(*7)
1
Speed CTL in REV mode by HND sw. (Fewer needle breakages)
OFF: Disabled
1: SYNC only Ushaft and feed
2: SYNC for Ushaft and feed, AUTO Decelerate to Ushaft SET at
MSW-456
456
300
～
4000
(sti/min)
4000
(sti/min)
100
Auto deceleration speed when reverse movement by hand sw
459
ON/OFF
OFF
－
Auto running mode
ON: Auto running function is enabled
OFF: Auto running function is disabled
(*) This is always reset to "OFF" when the power is turned on.
460
0.1
～
10.0
(seconds)
5.0
0.1 Auto running ON time
(*) Only displayed when MSW-459 is set to "ON"
This is only enabled when the main sewing is normal sewing or
pleat presser sewing.
During auto running mode, the sewing machine motor operates for the set
time.