Brother S-7300A - Software Version Updating Method

S-7300A
3. FUNCTION SETTINGS
35
3-11. Software version updating method
When updating the main control program version
1
<Preparation for updating the program version>
1. The main control program (ISM20MN.BVP) can be found in the following folder in the USB media.
¥BROTHER¥ISM¥ISMSYS¥
2.
Connect the card reader which has the USB media inserted to the USB port.
2
<Starting software version update mode>
1. While pressing the half stitch key, turn on the power to switch to the version
update selection screen.
3
<Version update selection mode>
1. Check that the version number (1) for the main control program that you are
going to update is correct.
2. Press the upper Update key (2) to start the version update.
4
<While version updates are running>
1. While version updating is in progress, the progress status will be displayed.
* Do not turn off the power while version updating is in progress.
2. Once version updating is finished, turn off the power.
(2)
(1)