Brother TC-32B - Override of the Inside Circular Cutting

Chapter4 Preparation function (Tool offset function) TC-32B
2004/01/22 4 - 30 eTCOMNCPR4.doc
4
4.1.11.2 Override of the inside circular cutting
When cutting along the circular arc whitch is offset inside during the offset mode,
the actual feedrate is calculated by multiplying the commanded feedrate by Rc/Rp.
Actual feedrate = Commanded feedrate ×
(Note 1)
When the value of Rc/Rp becomes smaller than the OVERRIDE LMT IN INSIDE ARC
set by the parameter 1, multiply that parameter value instead of Rc/Rp.
Actual feedrate = Commanded feedrate
Rc
R
p
OVERRIDE LMT IN INSIDE ARC
100