TC-32B Chapter 8 Automatic work measurement
2004/01/30 8 - 21 eTCOMNCPR8-1.doc
8
measyrement
position
eNCPR9.30.ai
G120 Xa Yb Zc
When [G120 Xa, Yb, and Zc] is commanded, the probe moves to point P.
When the measurement data does not exist, NO MEASRUING DATA alarm will
occur.
8.4 Handling of the measured results
8.4.1 Display of the measured results
The following screen appears when [6] is pressed on the <PRODUCTION MONITOR MENU>
screen or the cursor is moved to [6. MEASUREMENT RESULTS] and [ENT] is pressed.
S07005u1.bmp
To Next Page
Loading...
