Brother TC-32B - Linear Calculation by Angle; Linear Calculation by X, Y Intervals

Chapter6 Preparation function (coordinate calculation) TC-32B
2004/01/22 6 - 4 eTCOMNCPR6-1.doc
6
6.3.2 Linear (angle)
With the reference point at the commanded coordinate, the coordinate values along the linear line
at the angle (θ°) formed by the X axis are calculated.
Command format G37 X_ Y_ I_ J_ K_ ;
X,Y: Coordinate of reference point
I : Interval between machning points
J : Angle intersecting the X axis
K : No. of machining (Max. 999)
eNCPR6.01.ai
(Note 1) When K is omitted, it is regarded as 1.
(Note 2) The reference point becomes the first machining point.
6.3.3 Linear (X, Y)
With the reference point at the commanded coordinate, the coordinate values added in the X and
Y directions respectively are calculated.
Command format G38 X_ Y_ I_ J_ K_ ;
X,Y : Coordinate of reference point
I : Interval on the X axis
J : Interval on the Y axis
K : No. of machining (Max. 999)