Chapter 3 Preparation Function TC-32B
2004/01/22 3 - 58 eTCOMNCPR3.doc
3
3.30 G code priority
(1) Executed correctly.
(2) Error
(3) The last G command is effective.
(4) One-shot is executed and the modal is updated.
(5) One-shot is executed and the modal is updated, but an error occurs when circle arc is
commanded.
(6) Executed when the modal is G0 or G01, but an error occurs when circle arc is commanded.
(7) G22 is executed when G22 is commanded and the model for G0 group is updated.
Both are executed when G23 is commanded.
(8) An error occurs when circular command is output.
(9) An error occurs while circular arc mode is selected.
(10) The one commanded after the block is executed.
When G80 group is executed, the model for G00 group is updated.
When G0 group is executed, G80 group is canceled.
(11) An error occurs, but both are executed when commanded with G80.
(12) One shot execution, modal cancellation.
(13) Executed correctly except when the XZ or YZ arc command is executed.
(14) An error occurs, but both are executed when commanded with G69.
(15) G00 group is executed. G80 is model cancelled.
(16) One shot is executed and the model is updated, but an error occurs when G54P is used.
(17) Both are executed when the G0 group and model updated are simultaneously with G80.
An error occurs when used simultaneously with G54P.
(18) An error occurs when G54P is used.
(19) An error occurs when G102, G103, G202, G203 are used.
(20) Only effect for G17.
(21) An error occurs when G102~G203, without G17 of XY flat selection.
(22) An error occurs when already set to the measurement rotation mode.
Only G17 is able to command for G168.
(23) An error occurs when Z axis is mirror mode.
(24) An error occurs when changing for during the measurement.
(25) G68 is effective. G168 is error.
To Next Page
Loading...
