Brother TC-32B - Peck Drilling Cycle (G83)

TC-32B Chapter 5 Preparation function (canned cycle)
2004/01/22 5 - 15 eTCOMNCPR5-1.doc
5
5.4.7 Peck drilling cycle (G83)
Command format G83 X _ Y _ Z _ R _ P _ Q _ F _ ;
eNCPR5.12.ai
• The cutting start point d is set by the parameter.
•
If the minus value is commanded for the cutting amount Q, the algebraic mark (-) is ignored.
R point
Z point
Q
Q
Return point
d
d
Dwelling for P sec
Rapid feed
Cutting feed