Brother TC-32B - Repeat Number of Canned Cycle

TC-32B Chapter 5 Preparation function (canned cycle)
2004/01/22 5 - 7 eTCOMNCPR5-1.doc
5
5.3.6 Repeat number of canned cycle
When drilling at an equal interval is repeated in the same canned cycle, use the address K and
specify the repeat number.
The command range of K is 0 - 9999.
K is effective only in the specified block.
If K is not specified, the value of K is regarded 1.
When K0 is specified, drilling is not executed. Then the specified drilling data are memorized and
the X and Y command are given, these axes move accordingly.
The programming of "X_Y_" commands the initial drilling position in incremental mode (G91).
If the absolute command (G90) is given, drilling is repeted at the same position.
(Example)
eNCPR5.04.ai
G81 X _ Y _ Z _ R _ K5F _ ; (in G91 mode)
G81 X _ Y _ Z _ R _ K5F _ ; (in G91 mode)
Final machining position
First machining position
Current position