Brother TC-32B - Working Coordinate System Selection (G54~G59)

Chapter 3 Preparation Function TC-32B
2004/01/22 3 - 38 eTCOMNCPR3.doc
3
3.15 Selection of working coordinate system
(G54~G59)
When 6 sets of the coordinate systems for each workpiece are set in the data previously,
necessary coordinates system can be selected by commanding the G54 through G59 codes.
Command format G54
·
·
·
G59
G54 : working coordinate system 1
G55 : working coordinate system 2
G56 : working coordinate system 3
G57 : working coordinate system 4
G58 : working coordinate system 5
G59 : working coordinate system 6
3.16 Additional working coordinate system
selection (G54.1)
Command format G54.1 Pn ;
Pn : Specification code for additional working coordinate
system.
n : 1~48
The working coordinate system can be selected from 48pairs using the above command.
G54 provides this function instead of G54.1.
Data setting method
1) The data can be confirmed or set on the working coordinate origin screen.
2) The data can be set by commanding G10 in the program.
Command format G10 L20 Pn X_Y_Z_ ;
Pn : Specification code for additional working
coordinate system.
n : 1~48
X,Y,Z :Setting value of workpiece origin offset value
When the absolute mode (G90) is selected, the commanded value is considered the offset value.
When the incremental mode (G91) is selected, the commanded value is added to the preset offset
value.
;