Brother TC-32B User Manual

TC-32B Chapter 3 Preparation Function
2004/01/22 3 - 57 eTCOMNCPR3.doc
3
3.29 Single direction positioning function (G60)
Command format G60 X_Y_Z_A_B_C_ ;
X, Y, Z, A, B, C: Command value of the axis for which single direction
positioning is performed.
Coordinate of end point for G90 and travel amount for G91
eNCPR3.25.ai
Operation is reset.
When the above command is executed, the axis moves from the end point for the preset travel
amount, and then moves to the end point.
G60 is a one shot command and the axis travel path is the same as that for G00.
The travel amount is set for the user parameter.
1) Single direction positioning is not performed for the Z-axis during a canned cycle, or the
XY-axes when they are moving for the preset amount of shift in the G76 and G87 cycles.
2) Single direction positioning is not performed for any axis that does not have the travel
amount set for the parameter.
3) Single direction positioning is performed even when 0 is specified for the travel amount.
4) An error will occur when G60 is used during tool compensation.
Single stop does not
Start point
Stop
Travel amount
End point
Start point

Brother TC-32B Specifications

General

Brand	Brother
Model	TC-32B
Category	Printer
Language	English