Brother TC-32B - Word Composition in Programs; Numerical Value Input and Range

TC-32B Chapter 1 Program Composition
2004/01/22 1 - 3 eTCOMNCPR1-1.doc
1
1.3 Compositiom of Word
A word is composed of an address and some digit of figures as shown below.
(Algebraic sign + or - may added before a numerical value.)
(Note 1) The address uses one of the alphabetical letters.
(Note 2) The address "O" can not be used except for comments.
1.4 Numerical Values
(1) Decimal point programming
Numerical values can be input in the following two ways and set by the user
parameter (Switch 1).
Command type 1 (Standard)
Programmed command Commanded axis Actual amount (mm) Actual amount (inch)
Feed axis 1mm 1 inch
1
Rotation axis 1 deg 1 deg
Rotation axis 1 mm 1 inch
1.
Rotation axis 1 deg 1 deg
Command type 2 (Minimum)
Programmed command Commanded axis Actual amount (mm) Actual amount (inch)
Feed axis 0.001 mm 0.0001 inch
1
Rotation axis 0.001 deg 0.001 deg
Rotation axis 1 mm 1 inch
1.
Rotation axis 1 deg 1 deg
(Note) User parameter : Refer to Instruction manual.
(2) Programmable range of address
The maximum number of digits is 9.
The digits less than the minimum range are ignored.
X
Address numerical value
Word
-1000