Brother TC-32B - Page 201

TC-32B Chapter 8 Automatic work measurement
2004/01/30 8 - 19 eTCOMNCPR8-1.doc
8
Boss ... Four-point measurement
1. Spindle orientation 180゜. The probe moves to the first measurement start point
of the X and Y axes.
2. The probe moves to the Z axis measurement height.
3. The first measurement is carried out (in the -X direction ).
4. The probe moves to the Z axis return point.
5. Spindle orientation 0゜. The probe moves to the second measurement start point
of the X and Y axes.
6. The probe moves to the Z axis measurement height.
7. The second measurement is carried out (in the +X direction ).
8. The probe moves to the Z axis return point.
9. Spindle orientation 180゜. The probe moves to the third measurement start point
of the X and Y axes.
10.The probe moves to the Z axis measurement height.
11.The third measurement is carried out (in the -Y direction ).
12.The probe moves to the Z axis return point.
13.Spindle orientation 0゜. The probe moves to the fourth measurement start point
of the X and Y axes.
14.The probe moves to the Z axis measurement height.
15.The fourth measurement is carried out (in the +Y direction ).
16.The probe moves to the Z axis return point.
eNCPR9.28.ai
3RD
4TH
2ND
1ST